♦
To prolong the service life of the accessory tool,
ensure that you apply even pressure .
♦
Use of excessive pressure does not lead to a
greater removal rate, but rather to increased
wear of the accessory tool .
♦
Lift the appliance off the working surface .
♦
For internal extraction:
Let the power tool run for a few more seconds
to remove the remaining dust from the suction
hose
.
Sanding close to the edge
If you are sanding close to the edge, you can
remove a hood segment
suction hood
. This means that the accessory
tool you are using is closer to floor, wall and ceil-
ing edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined .
Expect dust to develop during this work, as the pro-
tective and suction hood
♦
Pull the hood segment
protective and suction hood
♦
Work the surfaces close to the edge .
♦
Push the hood segment
hood
until it locks into place .
Operation
■
Tool direction of rotation!
Switching on
♦
To switch on the appliance, slide the On/Off
switch
forwards .
To lock the On/Off switch
switch
down at the front until it clicks
into place .
Switching off
PWBS 180 A1
of the protective and
is no longer closed off .
forwards out of the
.
back into the suction
, press the On/Off
♦
To switch off the power tool, let go of the On/
Off switch
. If it is locked, press the rear end
of the On/Off switch
Setting the rotational speed
Before starting work, set the speed to suit the
application . Use a low speed for coarse sanding;
increase the speed for fine sanding .
■
Adjust the speed by pressing the buttons
♦
Press the + button
Press the – button
♦
NOTE
►
The accessory tool rotates after switching off .
Wait until the accessory tool has come to a
standstill before putting down the appliance .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work on the appliance.
■
The appliance is maintenance-free .
■
Do not use any sharp objects for cleaning
the appliance. Do not allow any liquids to get
into the appliance. The appliance could be
damaged .
■
Clean the appliance regularly, preferably imme-
diately after completion of the work .
■
Clean the housing with a dry cloth – do not use pet-
rol, solvents or cleaners that can attack the plastic .
■
Never obstruct the ventilation openings .
■
Remove any adhering swarf with a brush .
NOTE
►
Unlisted replacement parts (such as carbon
brushes, switch) can be ordered via our
service hotline .
Emptying the dust bag
To ensure optimum dust extraction, empty the dust
bag
regularly .
♦
Open the zip on the dust bag
♦
Shake out the dust bag
container .
GB │ IE │ NI │ CY
and then release it .
.
to increase the speed .
to decrease the speed .
.
over a suitable waste
│
11
■