Initial Use; On / Off Switch; Setting The Oscillation Speed; Cleaning And Maintenance - Parkside PAMFWP 20-LI A1 Originalbetriebsanleitung

Insert the insertion tool in the tool holder.
Note: You can attach the insertion tools in the
tool holder in any lock-in position.
Tighten the tool by pushing the lever
again.
Check the insertion tool is firmly seated.
Incorrectly or not securely attached insertion
tools can release during use, causing injuries.

Initial use

On / Off switch

Switching on:
Slide the ON / OFF switch forward to switch
on the tool.
The LED light comes on when switched on
11
and lights up the work area in poor lighting
conditions.
Note: The LED light
additional approx. 10 seconds after switching
off the tool (ON/OFF switch
Switching off:
Slide the ON/OFF switch
off the tool.

Setting The Oscillation Speed

Use the oscillation speed adjustment wheel
to set the oscillation speed.
Setting 1: low oscillation speed
Setting 6: high oscillation speed
Note: The oscillation speed required
varies by material and working conditions and
can be determined with tests.

Cleaning and maintenance

RISK OF INJURY!
Always switch the tool off and remove the
battery before working on the tool.
26 GB/IE
down
1
will stay on for an
11
released).
2
back to switch
2
7
Do not use sharp objects to clean the tool.
Never allow any liquids to enter the tool. The
tool may otherwise be damaged.
Routinely clean the tool, preferably promptly
after use.
Clean the housing with a dry cloth. Never use
petrol, solvents, or cleaning agents which
damage plastic.
Use a vacuum to deep clean the tool.
The vents must always be clear.
Use a brush to remove dust clinging to the tool.
When storing a lithium-ion rechargeable
battery for extended periods, regularly check
the battery charge. The optimal battery charge
is between 50 % and 80 %. The optimal
storage conditions are cool and dry.

Disposal

The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities. The
Green Dot is not valid for Germany.
Observe the marking of the packaging
materials for waste separation, which
b
a are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and
fibreboard / 80–98: composite
materials.
The product and packaging materials are
recyclable, dispose of it separately for
better waste treatment. The Triman logo
is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening