Technical Data; Safety Instructions; Symbols And Icons - Parkside PLS 2600 A1 Originalbetriebsanleitung

GB IE NI

Technical data

Electric leaf
vacuum/blower ..........PLS 2600 A1
Rated input voltage U..230 - 240 V~, 50 Hz
Rated power P ...........................2600 W
Idling speed n .....................11000 min
1
Idling speed n .....................14000 min
1
Air speed ........................max. 260 km/h
Air suction volume ............max.12 m
Chopping rate ................................ 10:1
Collection bag ........................... ca. 34 l
Protection class ................................
Protection category........................... IPX0
Weight (incl. accessories) ..................3 kg
Sound power level (L
guaranteed ............................ 98 dB(A)
Blow mode
Sound pressure level
) .................. 81.7 dB (A); K
(L
pA
Sound power level (L
measured ...... 90.9 dB(A); K
Vibration (a )
h
handle ..............2.54 m/s
T handgrip ........2.82 m/s
Suction Mode
Sound pressure level
) .................. 83.5 dB (A); K
(L
pA
Sound power level (L
measured ...... 95.3 dB(A); K
Vibration (a )
h
handle ..............2.52 m/s
T handgrip ........2.72 m/s
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
6
3 /min
)
WA
= 3 dB
pA
)
WA
= 2.14 dB
WA
; K= 1.5 m/s
2
; K= 1.5 m/s
2
= 3 dB
pA
)
WA
= 2.14 dB
WA
; K= 1.5 m/s
2
; K= 1.5 m/s
2
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
-1 value depending on the manner in
which the power tool is used.
-1
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
II when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Safety instructions

This section describes the basic
safety rules when working with the
2
device.
2

Symbols and icons

Symbols on the appliance
Warning!
2
Read the manual.
2
Danger due to materials
blown out of machine!
Remove persons in the
vicinity from the danger
area.
Caution.
Rotating impeller wheel.
Keep hands away.