Cleaning And Maintenance; Cleaning - Parkside PLS 2600 A1 Originalbetriebsanleitung

GB IE NI
• Make sure the volumes of leaf material
sucked in at one time are not too large.
This will avoid clogging of the suction
tube ( 13) and blockage of the im-
peller wheel.
To reduce wear on the collection
bag, do not drag it along the
ground while working.
Overload protection: The motor
will cut out immediately if overload-
ed.
Turn the leaf vacuum off and re-
move the mains plug. Then check
whether the impeller is blocked or
the collection bag clogged and re-
move the obstacles if they are.
The tool cannot be used until it has
completely cooled down again.
Emptying the collection bag:
With full collection bag, the suction pump-
ing capacity decreases considerably and
the collection bag must be emptied when
the bag is full or interferes with the suction
capacity of the device.
1. Turn off the device and wait until the
impeller has stopped.
2. Unplug the device.
3. Remove the carabiner (16) from the
eyelets (14). Release the collection bag
by pressing the locking button (9).
4. Open the zip-fastener on the collection
bag and empty it completely.
5. Mount the emptied collection bag
again.
Composting material does not be-
long with domestic waste!
16
Cleaning and
maintenance
Warning! Risk of injury by
dangerous moving parts!
Always clean the device
immediately after working with
it, as otherwise dirt will become
hardened and firmly attached
with leaf residues and might prove
impossible to remove without
dismantling the motor housing.
Such cleaning work is not covered
by the warranty.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing and remove
the mains plug
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.