Residual Risks; Initial Start-Up; Mounting The Blower/Suction Pipe - Parkside PLS 2600 A1 Originalbetriebsanleitung

Recommendation:
• Connect the device, as far as
possible, only to a plug socket
with a ground-fault circuit inter-
rupter (RCD), with a rated re-
sidual current at not more than
30 mA.
• Avoid operating the machine in
poor weather conditions, espe-
cially when there is a lightning
hazard.

RESIDUAL RISKS

Even if properly operating and
handling this electric tool, some
residual risks will remain. Due to its
construction and build, this electric
tool may present the following haz-
ards:
a) Ear damage if working without
ear protection.
b) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
c) Lung damage, if suitable res-
piratory protection is not worn.
d) Eye injuries if no suitable eye
protection is worn.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. In order to reduce
the danger of serious or fa-
tal injuries, users who wear
medical implants must consult
their doctor and the manu-
facturer of the implant before
operating the machine.

Initial start-up

Before operating the equipment, you must
- install the blower or suction pipes
(please note the order),
- install the collection bag for suctioning
leaves.
Caution! Risk of injury!
During the assembly or dis-
assembly of the blower pipe,
suction pipe or collection bag,
the device must be turned off
and all moving parts must
have come to a standstill.
Always disconnect the plug
from the mains socket before
working.
Mounting the blower/
suction pipe
1. Push the central pipe (15) into the mo-
tor housing (5).
2. Fasten the central pipe (15) using the
Phillips screws (18).
Blowing mode
3. Slide the blower pipe (11) into the cen-
tral pipe (15).
Vacuum mode
4. Place the suction pipe (13) on the cen-
tral pipe (15). The suction pipe clicks
into place.
5. Clip the suction pipe (13) into the blow-
pipe (11) support.
GB IE NI
13