Equipment And Scope Of Delivery; Technical Data - Mettler Toledo InPro 8000 Serie Bedienungsanleitung

6
1.2
1.3
InPro ® 8000 Series
52 800 247
Downloaded from www.Manualslib.com

Equipment and scope of delivery

Scope of delivery
The sensors of the InPro
fiber optic cable. Each sensor is accompanied by this instruction manual.
A METTLER TOLEDO Process System for the measurement of turbidity or of
suspended particles is completed by a METTLER TOLEDO Turbidity Trans-
mitter Type Trb 8300 (order no. 52 800 204). Detailed information for
calibration of the measuring system can be found in the following relevant
transmitter instruction manuals:
German
English
French
Packaging
The packaging consists of cardboard and foamed plastic. Safekeep the
packaging for later use during storage or transportation of the sensor. Should
you wish to dispose of the packaging material, please observe your local
regulations as well as those data and instructions given in chapter 5.3 of
this manual.
Unpacking and inspection
Please check the sensors immediately during unpacking in order to
determine possible damage or missing items. Any irregularities should
immediately be notified to your carrier and to your supplier.

Technical data

Function
Sensors of the InPro ® 8000 Series are optical sensors which measure the
concentration of suspended particles in a liquid medium on the basis of the
principle of backscattered light. The Transmitter Trb 8300 is equipped with
a LED which beams a light – almost in the infra-red range (wavelength 880
nm) – via a fiber optic cable into the liquid medium. If the light hits on par-
ticles, then it is scattered in all directions. The light scattered at an angle of
manuals search engine
® 8000 Series are delivered ready for use including
Order no. 52 800 243
Order no. 52 800 244
Order no. 52 800 245
© 01/04 Mettler-Toledo GmbH, CH-8606 Greifensee
InPro ® 8000 Series
Printed in Switzerland