Hilti DCG 230-D Bedienungsanleitung Seite 29

Information about the power tool and its applications
Drive spindle thread (arbor size)
Spindle length
Protection class as per EN / IEC
NOTE
en
The vibration emission level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a
preliminary assessment of exposure. The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly increase the exposure level over the total working
period. An estimation of the level of exposure to vibration should also take into account the times when the
tool is switched off or when it is running but not actually doing the job. This may significantly reduce the
exposure level over the total working period. Identify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
Noise information (as perEN 60745):
Typical A-weighted sound power level, DCG 230
Typical A-weighted emission sound pressure level,
DCG 230
Typical A-weighted sound power level, DAG 230
Typical A-weighted emission sound pressure level,
DAG 230
Uncertainty for the given sound level
Vibration information in accordance with EN 60745 1
Triaxial vibration values (vibration vector sums) for
the DCG 230 D
Surface grinding with the vibration absorbing side
handle, a
h,AG
Uncertainty (K)
Triaxial vibration values (vibration vector sums) for
the DAG 230 D
Surface grinding with the vibration absorbing side
handle, a
h,AG
Uncertainty (K)
Additional information
24
Printed: 22.04.2013 | Doc-Nr: PUB / 5069494 / 000 / 00
M 14
25 mm
Protection class II (double insulated)
101 dB (A)
90 dB (A)
101 dB (A)
90 dB (A)
3 dB (A)
measured in accordance with EN 60745 2 3
5.0 m/s
1.5 m/s
measured in accordance with EN 60745 2 3
5.0 m/s
1.5 m/s
Other applications such as cutting or wire brushing
may produce vibration values different to those
given.