Hilti DCG 230-D Bedienungsanleitung Seite 26

Use only grinding discs, cutting discs and other accessories of max. 230 mm diameter that are approved for
use at a speed of at least 6500 /min.
For this application, use only synthetic resin-bonded fiber-reinforced abrasive cutting discs approved for use
at a peripheral speed of at least 80 m/sec.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
Modification of the power tool or tampering with its parts is not permissible.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there
is a risk of fire or explosion.
2.2 Grips
Vibration-absorbing grip
Pivotable hoop grip
2.3 Switches
On / off switch (hold to run)
2.4 Items supplied as standard include:
1 Power tool
1 Guard
1 Side handle
1 Clamping flange
1 Clamping nut
1 "Kwik-Lock" clamping nut (optional)
1 Wrench
1 Operating instructions
1 Protective glasses (optional)
2.5 Starting current limitation
The electronic starting current limiter reduces the starting current drawn by the power tool and thus prevents
the mains fuse blowing. It also allows the power tool to start smoothly, without a jolt.
2.6 ATC (Active Torque Control)
The electronics in the power tool detect situations where there is a risk of the disc sticking and prevent further
rotation of the drive spindle by switching the power tool off (does not prevent kickback). The switch must be
released and pressed again to restart the power tool.
Printed: 22.04.2013 | Doc-Nr: PUB / 5069494 / 000 / 00
en
21