Hilti DCG 230-D Bedienungsanleitung Seite 27

NOTE
In the event of a fault in the ATC system, the power tool will continue to run but at greatly reduced speed and
with lower torque. The power tool must be returned to Hilti Service for servicing.
2.7 Restart interlock
The power tool does not restart by itself when the switch remains pressed and the power returns after an
interruption in the electric supply. The switch must first be released and then pressed again to restart.
en
2.8 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise loose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cord lengths
Conductor cross section
Mains voltage 100V
Mains voltage 110-127 V
Mains voltage 220-240 V
Do not use extension cords with 1.25 mm conductor cross section.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.
2.11 DC EX 230/9" disc guard with guide carriage for cutting 2
The power tool may be used for cutting work on mineral materials only when fitted with a disc guard (dust
removal hood) and guide carriage.
CAUTION
Use of this guard for working on metal is not permissible.
NOTE
It is recommended that a dust removal system consisting of matched components, i.e. dust removal hood and
a suitable Hilti vacuum cleaner, are used for cutting, grinding and slitting work on mineral materials such as
concrete or stone. This system serves to protect the operator and increase the life of the power tool and disc
used.
22
Printed: 22.04.2013 | Doc-Nr: PUB / 5069494 / 000 / 00
1.5 mm 2 mm
30 m
20 m 30 m
50 m
2.5 mm 3.5 mm
50 m
40 m 50 m
100 m