1.
INPUT SELECTION
Once in the SENSOR CONFIG menu, select
the analogue input where the sensor output
is physically wired.
2.
CHOOSE THE SENSOR TYPE
Select what kind of sensor is connected to
that input.
See the menu diagram for the complete list
of supported sensors.
Select "Custom" for importing the complete
input configuration from the PC Veratron
Configuration Tool.
CONFIGURE THE NMEA 2000 OUTPUT
3.
The measured value for the configured
analog sensor is also transmitted over NMEA
2000, so the OceanLink display will act as a
source for that data.
Use the menu item "Show Value As" to
modify the NMEA 2000 instance for that
sensor.
If a configuration conflict is detected in the
setup (like when two sensors with same
instance are configured on different analog
ports), the display will show a warning.
SENSOR CONFIGURATIONS
A2C15587600