Cc-Link Connection; Connecting Sensors/Actuators - Balluff BNI CCL-502-100-Z001 Betriebsanleitung

Balluff Network Interface – CC-Link – BNI CCL-502-100-Z001
3 Getting Started
3.5. CC-Link
Connection
3.6. Connecting
sensors/actuators
www.balluff.com
The CC-Link connection is made using the M12 sockets Bus In and Bus Out (A-coded).
CC-Link-Bus In: (M12, A-coded, male)
PIN
CC-Link Bus Out: (M12, A-coded, female)
PIN
Pin
M12
A-coded
female
Note
Unused port sockets must be fitted with cover caps to ensure IP67 protection rating.
Note
For the digital sensor inputs follow the input guideline per EN61131-2, type 2.
Note
The IO-Link output is supplied with power via the sensor supply.
Note
Due to limited CPU resources, only a maximum of three IO-Link-devices with
COM3 speed can be reliably handled. It is therefore recommended not to use all
4 IO-Link-Ports for COM3 IO-Link Devices simultaneously.
Note
All ports are configured as SIO Input port by factory default.
Until the device is not connected to any CC-Link Master device, all the ports operate
as input, although the input data is not transmitted just the Function Indicator LEDs
operate.
Requirement
1 SLD
2 DB
3 DG
4 DA
Requirement
1 SLD
2 DB
3 DG
4 DA
Input/Output
+24V
1
0.2 A
Input /
2
Output 2A
3 0V
Input /
4
Output 2A
5 FE
Description
Shield
B-Line (white)
Ground (yellow)
A-Line (blue)
Description
Shield
B-Line (white)
Ground (yellow)
A-Line (blue)
Function
Input/Output
IO-Link
+24V
1.6A
Input /
Output 2A
0V
Input /
Output 1.6A /
IO-Link
n.c.
8