Balluff BNI CCL-502-100-Z001 Betriebsanleitung Seite 63

Balluff Network Interface – CC-Link – BNI CCL-502-100-Z001
6 Acyclic messaging
Detailed error code list (in firmware FW3.8)
Error code
0x00
0x11
0x12
0x20-0x22
0x23
0x30
0x31
0x32
0x33
0x34
0x35
0x36
0x40
0x41
0x80
0x81
0x82
0x84 – 0xDF
0xE0
0xE1
0xE2
0xE3 – 0xEF
0xF0
0xF1
0xF2
0xF3
0xF4
0xF5
0xF6
0xF7
www.balluff.com
Source of error
N/A No error. Last command is successful.
IOL Device ISDU Index not available
IOL Device ISDU Subindex not available
IOL Device Service temporarily not available
IOL Device - Access denied for ISDU Write command: Index is
read only
- Access denied for ISDU Read command: Index is
write only
IOL Device Parameter value out of range
IOL Device Parameter value above limit
IOL Device Parameter value below limit
IOL Device Parameter length overrun
IOL Device Parameter length underrun
IOL Device Function not available
IOL Device Function temporarily not available
IOL Device Invalid parameter set
IOL Device Inconsistent parameter set
IOL Device - Application not ready (in the IOL device)
- Other error, but no detail/info available in the IOL
device
IOL Device Vendor specific error in the IOL Device.
Error details not forwarded even if it produced by the
IOL Device.
Check the IOL Device's documentation about
possible error cases.
IOL Device - Timeout (the IOL Device does not response in 5
seconds)
- CRC checksum error in IOL communication
- Illegal service primitive (in IOL Master module in
CCL-502)
N/A Not used.
CC-Link Timeout in CC-Link Acyclic (Transient)
communication
CCL-502 Invalid IOL Port number (valid: 0-3)
CCL-502 Data length exceed max length for ISDU Write
command
N/A Not used.
CCL-502 Unexpected error. No details available.
CCL-502 Length error
CCL-502 Invalid command
CCL-502 Timeout
CCL-502 Index not found
CCL-502 Access violation
CCL-502 Number of IO-Link ports must be 4
CCL-502 Index not found of the 'Module Info'
Description
22