Port; Mechanical Connection; Electrical Connection; Power Supply - Balluff BNI CCL-502-100-Z001 Betriebsanleitung

3 Getting Started

3.2. Port

3.3. Mechanical
connection
3.4. Electrical
connection

Power supply

Function ground

www.balluff.com
BNI CCL-502-100-Z001
The module is attached using 2 M6 screws and 2 washers.
Power In (7/8", 5 pin, male)
PIN
1
2
3
4
5
Power Out (7/8", 5 Pin, female)
PIN
1
2
3
4
5
Note
24 V DC.
Provide sensor/bus power and actuator power from separate power sources if
possible.
Total current <9A. The total current of all modules may not exceed 9A even when
daisy chaining the actuator supply.
Note
The FE connection from the housing to the machine must be low-impedance and
kept as short as possible.
0, 1, 4, 5
Input/Output (PNP)
Signal
GND module / sensor and actuator
0 V
FE
+24V Module- / sensor supply (US)
+24V
Signal
GND module / sensor and actuator
0 V
FE
+24V Module- / sensor supply (US)
+24V
Port
2, 3, 6, 7
Input/Output (PNP)
IO-Link
Description
supply
Function Ground
Actuator supply (UA)
Description
supply
Function Ground
Actuator supply (UA)
7