Operation With The Ir Remote Control; Dmx Operation - EuroLite LED KLS-3002 Next Bedienungsanleitung

Operation with the IR remote control

The IR remote control allows convenient control of the integrated show programs in automatic mode or
sound-controlled mode, and the color mode with preset colors. The IR remote control will only work in stand-
alone mode, it will not work in DMX or slave mode Press the buttons repeatedly to switch between the
programs. The display indicates the current setting. When actuating a button, always hold the remote control
in the direction of the sensor at the control unit's front or rear. A direct line of sight between the remote
control and the sensor is required. The remote control can be activated/deactivated in the system settings.
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 28 control channels.
However, it can also be switched to a mode with 2, 4, 6, 10 or 24 channels if different functions are required.
To be able to operate the device with a DMX controller, the DMX starting address must be set for the first
DMX channel. The starting address depends upon which DMX controller is being used. Please refer to the
controller's documentation.
1 Press the button MENU so many times until dПH is indicated in the display. Confirm with the ENTER
button. The display indicates the DMX start address.
2 Confirm with ENTER. The display indicates 2CH (2 DMX channels), 4CH (4 DMX channels), 6CH (6
DMX channels), 10CH (10 DMX channels), 24CH (24 DMX channels) or 28CH (28 DMX channels). Use
the UP and DOWN buttons to select the desired number of DMX channels.
3 Confirm with ENTER. Now the display indicates the menu item for the DMX start address d***. Confirm
with ENTER, then use ▲ and ▼ to set the address.
4 Confirm ENTER. A dot will flash when DMX signals are being received. If no control signals are
available, the DMX address set will be flashing.
5 You can adjust the behavior in case of missing DMX signal in the system settings under the menu item
SYS > FAIL: HOLD = Most recent DMX value is held or BLAC = LEDs are switched off (default setting).
Note: Please make sure you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture in the DMX chain. If several devices are addressed similarly, they
work synchronically.
Button
On/off
Switch through automatic programs 1-20
Switch through sound-controlled programs 1-20
Pause / play
/ Set running speed for automatic mode
Color selection for color mode
1 –
—
No function
–
—
/ / No function
—
Function
30/36 00122642, Version 1.1