Operation With The Ir Remote Control - EuroLite LED KLS-170 Bedienungsanleitung

Operation with the IR remote control

The IR remote control allows convenient control of the integrated show programs in automatic mode or
sound-controlled mode, and the color mode. The IR remote control will only work in stand-alone mode, it will
not work in DMX or slave mode Press the buttons repeatedly to switch between the programs. The display
indicates the current setting. When actuating a button, always hold the remote control in the direction of the
sensor at the control unit's front or rear. A direct line of sight between the remote control and the sensor is
required. The remote control can be activated/deactivated in the system settings.
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
Button
On/off
Show program AM01—AM03 in automatic mode
Show program SM01—SM03 in sound-controlled mode
Show program AP01—AP17 or SP01—SP12 for the LED spots
Show program AF01—AF10 or SF01—SF10 for the strobe LEDs
Switching between automatic mode/sound-controlled mode
Pause
/ Color selection (CoLo mode): R G RG B RB GB RGB
Running speed of the show programs in automatic mode
–
-
26/32
Function
00121009, Version 1.1