Operation With The Ir Remote Control - EuroLite LED KLS Scan Next FX Bedienungsanleitung

Operation with the IR remote control

The IR remote control allows convenient control of the integrated show programs in automatic mode or
sound-controlled mode, and a color mode with preset colors for the derby, LED spots and scanners. The IR
remote control will only work in stand-alone mode, it will not work in DMX or slave mode. Press the buttons
repeatedly to switch between the programs. The display indicates the current setting. When actuating a
button, always hold the remote control in the direction of the sensor at the control unit's front or rear. A direct
line of sight between the remote control and the sensor is required. The remote control can be
activated/deactivated in the system settings.
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
Button
On/off
Switch through automatic programs 1-20
Switch through sound-controlled programs 1-20
Pause / play
Set running speed for automatic mode
-
Color selection for color mode
Color switch / fade
,
No function
No function
, ,
41/56
Function
00132156, Version 1.0