Automatic Setup-Mode, Deletion And Automatic Setting Of The End Positions - Selve commeo SE Pro-com Betriebsanleitung

commeo initial operation/setting by radio
Note for settings under point 6.2.: The motor must be selected for this setting with a trans-
mitter in SELECT mode (Status LED flashes slowly in orange). After completing the setting,
the motor is still selected (see point 6.).

6.2.1. Automatic setup-mode, deletion and automatic setting of the end positions

in operation bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in automatic
setup-mode. Motor types SE Pro-com will automatically find their stop positions. For this, a
motor must first move against the upper stop and then downwards until it switches off auto-
matically.
Operation
9 s
or
Auto-Stop top
and bottom, keep
motion button pressed
Drive
Press the STOP button of the transmitter for 9 seconds.
Both limit positions already set will be deleted.
Note: Not required for the initial installation or after
resetting to factory defaults.
Move the motor upwards with the UP or DOWN button.
STOP
STOP
The motor moves against the upper stop and stops
automatically. The correct direction of rotation assign-
ment has been made.
Continue to keep the button pressed. The motor auto-
matically moves downwards after 1–2 seconds. Alterna-
tively move the motor downwards using the DOWN
button.
Note: The motor can be moved upwards and down-
wards. As long as the lower end position has not been
found, the downwards moving will be interrupted
twice.
The motor will reach the lower limit and stops automa-
tically. The end positions are now set and the rotation
direction assignment is correct. Perform a test run.
Note: The transmitter may not yet have been program-
med. See point 6.2.4. to program a transmitter.
43
EN