Technical Data; General Declaration Of Conformity - Selve commeo SE Pro-com Betriebsanleitung

Technical data/General declaration of conformity

7. Technical data

Series
1/6
1/10
2/7
2/10
2/15
2/20
2/30
2/40
2/50
Installation location:
After installing the drive, mark the drive type in the technical data table and make a note of
the installation location.
Series 2 motors have a plug-in connection cable. Series 1 motors have a 3 m mains cable as
standard which is permanently installed and cannot be replaced.
The relevant cable lengths and qualities for series 2 can be selected in the catalogue.
Connection cables must be ordered separately.
Information about connections using special connectors must be requested.
Information for all motor types:
Nominal voltage: 230 V AC/50 Hz
Standby consumption: 0.5 W
Safety class: IP 44
Operating time: 4 min.
Radio frequency: 868.1 MHz
Max. transmission output: 10 mW
Note: The maximum radio range is up to 25 m indoors and up to 350 m in the open field.
Subject to change without prior notice!

8. General declaration of conformity

SELVE GmbH & CO. KG company, hereby declares that the SE Pro-com is in conformity with
the basic requirements and other relevant provisions of the Directive 2006/42/EG, 2014/53/
EU, 2014/30/EU and 2011/65/EU. The declaration of conformity can be looked up at
www.selve.de
Torque Rotation speed
Nm Rpm
6 15
10 15
7 17
10 17
15 17
20 17
30 17
40 17
50 12
47
Power Input Output
A
0.45
0.45
0.41
0.55
0.66
0.75
0.95
1.50
1.50
W
105
105
95
124
152
172
220
345
345
EN