Setting Of The End Positions; Delivery Status; Mechanic Requirements; Setup Functions - Selve commeo SE Pro-com Betriebsanleitung

Setting of the end positions

4. Setting of the end positions

4.1. Delivery status

In the SELVE delivery status no end positions or transmitters are programmed into
the radio motor! In this state, the motor can be operated in deadman's operation only. Safety
functions such as obstacle detection are deactivated at delivery and will only become active
after both end positions are set.
State at delivery is indicated by a short movement when the radio motor is connected to
power. The SE Pro-com motor is in automatic setup-mode.

4.2. Mechanic requirements

Operating of the SE Pro-com motor is possible with normal safety and fixing springs. Option-
ally, security springs can also be used (manual setup-mode).
If the motor is supposed to move against the stop in the upper end position, a stable end stop
must be installed!
If the motor is set in automatic setup-mode, a limit must be installed for the lower switchoff
position (e.g. windowsill) for the shutter to run against.

4.3. Setup functions

The end positions setting of a SELVE radio motor is possible via:
• the setting switch for radio motors (item no. 290109 or 291009),
• any standard switch (in automatic mode),
• any standard commeo transmitter.
34