Comfort Switching Off - Selve commeo SE Pro-com Betriebsanleitung

Comfort switching off

5. Comfort switching off
The relief function at the upper end limit is subsequently disengageable: When comfort
switching off is set, the drive will stop automatically at a point shortly before the upper end
limit. Every 30th move is a reference move against the upper end limit plus relief.
Therefore the noise development when switching off above will be reduced.
A requirement for the setting of the comfort switching off: both end limit positions must be
set, move against the upper end limit plus relief.
Setting with Setting with
switch setting switch
1 s
E
approx. 3 s
The comfort switching off can also be executed via radio with a commeo hand-held transmit-
ter/wall send. This process is described in chapter 6.2.7. CONFIGURATION mode.
Drive
E
E
1 s
approx. 3 s
Move the drive upwards until it stops automat-
ically at the upper end limit.
Press the UP button for 1 second.
Press the UP button for approximately 3 sec-
onds until the drive executes a short confirma-
tion move.
When executing this procedure once again it
will lead to the deactivation of the comfort
switching off.
39
EN