Installation And Electrical Connection; Installation Of The Motor Into A Shaft - Selve commeo SE Pro-com Betriebsanleitung

Installation and electrical connection

3. Installation and electrical connection
Caution! Risk of injury through an electric shock!
Connection only when de-energised!
Run the motor only after installation.
Warning!

3.1. Installation of the motor into a shaft

1. Attach crown and coupling adapter to the motor and fasten them with the
locking device
2. Push the motor into the shaft in a positive-locking way. The motor must not be subject to
any impacts. Crown and coupling adapters must not have any play inside the shaft.
3. Where required, secure the motor axially, e.g. by screwing the shaft to the coupling adapt-
er. Do not drill holes into the motor area!
4. Attach the shaft with the motor and the shaft cap in the bearings. Do not bend the motor
cable and aerial and place them so that neither the aerial nor the motor cable cannot be
damaged. Do not place the aerial parallel to the motor cable. The aerial must not be short-
ened or extended. To keep water from getting into the motor, place the motor line in a
bend direction downwards, so that any water can drip off.
5. Attach the curtain to the shaft.
31
EN