Inhaltsverzeichnis
Werbung
AC MAGNETO AND STARTER CLUTCH
1 2 3
2
3. Install:
3
2
1
4. Install:
NOTE:
• Apply the molybdenum disulfide oil on the
• Apply the engine oil on the starter idle gear
5. Install:
NOTE:
• Clean the tapered portion of the crankshaft
• When installing the rotor, make sure the
6. Tighten:
NOTE:
• Tighten the rotor nut 1 while holding the
• Do not allow the sheave holder to touch the
1
7. Install:
NOTE:
• Pass the starter motor lead 1 and neutral
3
• Fasten the starter motor lead with the clamp 3.
4 - 46
• Spring 1
• Spring cap 2
• Pin 3
• Shim 1
• Starter wheel gear 2
• Starter idle gear 3
• Shaft 4
starter wheel gear inner circumference.
inner circumference and on the shaft outer
circumference.
• Woodruff key 1
• Rotor 2
and the rotor hub.
woodruff key is properly seated in the key
way of the crankshaft.
• Rotor nut 1
48 Nm (4.8 m · kg, 35 ft · lb)
rotor 2 with a sheave holder 3.
projection on the rotor.
Sheave holder:
YS-01880-A/90890-01701
• Crankcase cover (left)
switch lead 2 into the crankcase cover
groove as shown.
ENG
Werbung
Inhaltsverzeichnis
