Inhaltsverzeichnis
Werbung
BATTERY INSPECTION AND CHARGING/
a
1
FUSE INSPECTION
6. Install:
• Battery
• Battery band
7. Check:
• Battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
8. Lubricate:
• Battery terminal
Recommended lubricant:
Lithium soap base grease
9. Connect:
• Battery lead coupler
(to the battery terminals)
10. Install:
• Battery cover
• Seat assembly
FUSE INSPECTION
CAUTION:
To avoid a short circuit, always set the
main switch to "OFF" when checking or
replacing a fuse.
1. Remove:
• Seat assembly
• Battery cover
Refer
to
ASSEMBLY AND FUEL TANK" section in
the CHAPTER 4.
2. Disconnect:
• Battery lead coupler 1
(from the battery terminals)
NOTE:
Push down on the tab a, and then remove the
battery lead coupler.
3 - 30
INSP
ADJ
"FRONT
FENDER,
SEAT
Werbung
Inhaltsverzeichnis
