Husqvarna BMG 780 Bedienungsanweisung Seite 26

To engage and disengage the drive
system BMG 780 RC
1. Connect the wheels from the drive motor.
2. Start the product. Refer to
780 RC on page 15 .
3. Use the remote control to move the product.
Note:
An error message shows in the remote
control display if the locking pins are not correctly
attached.
4. To disconnect the wheels from the drive motor, pull
out the locking pins.
Support wheel BMG 780 RC
The support wheel lifts the grinding head a small
distance from the ground to make short distance
transportation easier.
CAUTION:
to move the product short distances. The
support wheel must only be used in the work
area or on and off a transportation vehicle.
WARNING:
install, remove or adjust the support wheel.
The moving parts can cause injury.
26
To start the product BMG
Use the support wheel only
Be careful when you
To install the support wheel BMG 780 RC
1. Make sure that the bracket (A) is attached correctly.
2. Lock the support wheel with the pin (B).
To adjust the height of the support wheel BMG
780 RC
1. Turn the lock lever (A) at the front of the support
wheel frame to loosen the support wheel.
2. Turn the handle (B) to lift or lower the support wheel.
3. Turn the lock lever (A) at the front of the support
wheel to lock the support wheel position.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
B
A
B
A
Be very careful when you
1811 - 001 - 02.05.2022