Husqvarna BMG 780 Bedienungsanweisung Seite 13

7. Attach new diamond tools to the tool plate with a soft
hit of the hammer.
8. Carefully lift the product with the handlebar to
operation position.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Connect the dust extractor hose to the connection
for dust extractor. Refer to
780 on page 3 for information about where the
connection for dust extractor is on your product.
To connect the water supply
CAUTION:
prevent dirt blockage in the water system.
WARNING:
and connections away from water.
WARNING:
extractor when wet grinding.
1. Connect the water kit to the water connector on the
product.
1811 - 001 - 02.05.2022
Do not use the dust
Product overview BMG
Use only clean water to
Keep all electrical cables
Do not use the dust
2. Connect the water hose to the water kit.
3. Start the water flow.
CAUTION:
water pressure than 30 psi. The water is
only to prevent dangerous dust in the air.
If water is necessary for your operation,
speak to a Husqvarna service agent for
more information.
To connect the product to a power
source
1. Connect the power plug (A) of the product to an
applicable extension cable.
2. Connect the extension cable to a mains outlet.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to a 3-phase
power source.
To adjust the height of the handlebar
WARNING:
the the handlebar. Make sure that the
handlebar locks into position. The moving
parts can cause injury.
During operation set the handlebar height as close
as possible to the height of the operators hip. During
operation the product can pull to the side. The hip of the
operator can help to stop this movement to the side.
Do not use a higher
A
When the product is
Be careful when you adjust
13