Husqvarna BMG 780 Bedienungsanweisung Seite 12

• Full set of diamond tools: This configuration is
applicable for a flat floor finish.
• Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.
To replace the diamond tools
WARNING:
power plug before you replace the diamond
tools, to prevent accidental start.
WARNING:
diamond tools can become very hot.
WARNING:
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the diamond tools. The
dust extractor will decrease the dust that can
cause health problems.
CAUTION:
always have the same number and type of
diamond tool segments. The height of the
12
Always disconnect the
Use protective gloves, as
Use approved respiratory
Use the dust extractor
All the diamond tools must
diamond tool segments must be the same
on all diamond tools.
1. Stop the product and disconnect the power plug.
To stop the product on page 18 .
Refer to
2. Adjust the handlebar to upright position. Refer to
adjust the height of the handlebar on page 13 .
3. Tilt the product rearward. Tilt the product until the
support bracket below the electrical enclosure is on
To tilt the product on page 21 .
the floor. Refer to
CAUTION:
power cord and the dust hose do not
become damaged when you tilt the
product.
CAUTION:
thin wood below the support bracket to
prevent damage to the floor.
WARNING:
product is in a stable position before you
replace the diamond tools.
4. Remove dust with the vacuum cleaner.
5. Use a hammer to remove the diamond tools from the
tool plate.
6. Clean the tool plate with the vacuum cleaner.
To
Make sure that the
Put a piece of cloth or
Make sure that the
1811 - 001 - 02.05.2022