HEIDENHAIN IK 320 Benutzerhandbuch Seite 59

break;
case 0x08:
puts ("Preset set via master\n");
break;
case 0x09:
puts ("Preset set via external function\n");
break;
default:
puts ("Unknown message code");
}
extucMessage = 0;
delay (3000);
}//End DisplayMessage
/*-------------------------------------------------------------------
DisplayError
This function displays the error messages of the
IK interrupt status.
------------------------------------------------------------------*/
void DisplayError(void)
{
gotoxy (1,23);
switch (extucErrorCode)
{
case 0x01:
puts ("Error: No latch on axis 1\n");
break;
case 0x02:
puts ("Error: No latch on axis 2\n");
break;
case 0x03:
puts ("Error: Double latch on axis 1\n");
break;
case 0x04:
puts ("Error: Double latch on axis 2\n");
break;
case 0x05:
puts ("Error: CRC correction value 1\n");
break;
case 0x06:
puts ("Error: CRC correction value 2\n");
break;
case 0x07:
puts("Error: parameter setting\n");
break;
case 0x08:
puts("Error: CRC Eprom\n");
break;
case 0x09:
puts ("Error: checksum EPROM 1\n");
break;
case 0x10:
puts ("Error: checksum EPROM 2\n");
break;
case 0x11:
puts ("Error: hardware\n");
break;
case 0x12:
puts ("Error: wrong parameter setting\n");
break;
case 0x13:
puts ("Error: axis 1 has no absolute reference\n");
break;
case 0x14:
puts ("Error: axis 1 has wrong speed\n");
break;
case 0x15:
puts ("Error: axis 1 has wrong position\n");
break;
case 0x16:
puts ("Error: axis 1 has wrong direction\n");
break;
"&Á