Elica NIKOLATESLA FIT Montage- Und Gebrauchsanweisungen Seite 23

Cooking Zones Timer
The Cooking Timer Zone function is a countdown that can be
set, also at the same time, on each cooking zone
At the end of the period set, the cooking zones switch off
automatically and the user is notified with a dedicated acoustic
signal.
Activation of the cooking zone timer function
• Touch (press) the Selection/Display area (2)
≠
(power level 0)
• Press (6) relating to the cooking zone
Use the symbols
Timer, which is displayed in the Zone/Display (4)
during setting the symbol
Note: wait 10 seconds without pressing any other command,
so that the Cooking Zone Timer will start.
Note: by pressing and holding
timer is reset
If desired, repeat the operation for several cooking zones.
Note: each cooking zone can have a different Timer set; in
the display (4) he countdown of the cooking zone selected at
that moment will appear; if no zone is selected, pressing the
Display (4) will display the "STAND-ALONE" Timer
countdown.
The countdown mode is the same as the "STAND-
ALONE" timer one (see previous paragraph "STAND
ALONE" Timer)
When the timer has finished the countdown, an acoustic
signal sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to
Power Limitation
The Power Limitation function allows the product to be used
while limiting its maximum absorption, adjusting the absorbed
power in all active cooking zones, ensuring the hob's total
absorbed power doesn't exceed the set maximum absorption
level.
Note: the setting must take place with the hob off, without
pressing the ON/OFF (1) key, when the hob is
connected to the mains, or when the electric mains are
reconnected within the following 2 minutes.
To set the Power Limitation:
(5) to set the duration of the
(6) is flashing
(6) , the cooking zone
, using
- press
(which will be flashing, only for the first 2 minutes after
powering of the product)
- continuing to hold down
areas of Selection/Display (2) of the cooking zones, anti-
clockwise starting from the front right zone (FR)
- each press will be accompanied by a short audible signal
- once all the Displays (2) have been pressed, it will be
possible to release the key
at this point:
- the Display (2) of the left rear zone (RL) will show in
alternate sequence the symbols
is possible to perform the setting:
select the Display (2-RL)then scroll on the Selection bar (3),
until the symbols
show the current setting**
** by default the setting is 7.4 KW
To change the Power Limitation setting
(5)
- press the Display (2) of the left front area (FL)
- then scroll on the Selection bar (3), to select the new setting
- to save the choice made, press the
for 2 seconds; a prolonged audible signal will be emitted to
confirm the successful setting
Bridge Zones
Thanks to the Bridge function, the cooking zones are able to
work in a combined manner, creating a single zone with the
same power level. This function allows evenly distributed
cooking with large-sized pots and pans.
23
press, one at a time, all the
" " "
C and 0
" " " "
C and 8 ,appear the Display (2-FL) will
0 = 7.4 KW
1 = 4.5 KW
2 = 3.1 KW
ON/OFF key (1),
"
, indicating that it