Grease Filter - Elica NIKOLATESLA FIT Montage- Und Gebrauchsanweisungen

4. Maintenance
Caution! Before any cleaning or maintenance, make sure
the cooking zones are switched off and the heat indicator
has turned off.
Hob maintenance
Cleaning
The hob must be cleaned after each use.
Important: Do not use abrasive sponges or pads, they may
ruin the glass. Do not use irritant chemical detergents such as
oven sprays or stain removers. After each use, let the hob
cool down completely to remove encrusted on dirt and stains.
Use a soft cloth, paper towel or specific products to clean the
hob (follow the Manufacturer's instructions).
DO NOT USE STEAM JET CLEANERS!!!
Important: In the event of the accidental spillage of large
quantities of liquid from pans it is possible to drain by using
the discharge valve, on the lower section of the product, in
order to remove any residues and ensuring maximum hygiene
levels are maintained. Fig. 16
Extractor fan maintenance
Cleaning
For cleaning, use ONLY a cloth moistened with neutral liquid
detergents. DO NOT USE CLEANING UTENSILS OR
TOOLS!
Avoid the use of products containing abrasives.
DO NOT USE ALCOHOL!
Cleaning the metal grille:
The grille must be washed by hand with hot water and neutral
detergent, then dried thoroughly to prevent oxidation.

Grease filter

Traps grease particles generated by cooking.
Must be cleaned once per month (or when the filter saturation
indication system indicates this need), with non-aggressive
detergents, either manually or in the dishwasher at a low
temperature and in a short cycle.
When cleaned in the dishwasher, the metal grease filter may
discolour, but its filtering characteristics remain unchanged.
Fig. 15.1.2 - 15.2.3
Activated Carbon Filter - Ceramic
(Only for Filtration Version)
Traps unpleasant odours generated by cooking.
The product comes with a set of odour filters. The saturation
of the odour filters can occur after somewhat prolonged use
depending on the type of cooking and how regularly the
grease filter is cleaned. The odour filters can be thermally
regenerated every 2/3 months in an oven pre-heated to 200°C
for 45 minutes. The correct regeneration of the filter ensures
that it can constantly filter efficiently for 5 years.
Warning! Do not leave filters on the bottom of the oven, but
place it on a baking tray and position it at a mid height..
Fig. 15.2.1
27