Charging, Cleaning And Troubleshooting; Charging The Av400 - AccuVein AV400 Benutzerhandbuch

Verify the charging cradle is properly connected (see the Set-
up section). Place the AV400 in the charging cradle with the
LCD facing outward to begin charging. While the AV400 is
in its charging cradle, the vein display light does not operate
and the device cannot be used. An animated battery charge
icon will display when the AV400 is charging. The light on the
charging cradle will only turn on when a device is detected. If
the light turns on when there is no device placed in the charg-
ing cradle please call AccuVein support for assistance.
To ensure the battery remains charged and ready for use,
store the AV400 in its charging cradle or a powered Accu-
Vein accessory.
CAUTION: Use only the AccuVein® PS310 power sup-
ply with the CC300 cradle and other AccuVein approved
accessories.
-AV400_RevC_compiled.indd 13
Production 1Pc after translations

Charging, Cleaning and Troubleshooting

Charging the AV400

When the AV400 battery gets low the battery indicator will
ash yellow or red and beep repeatedly. Before the battery is
completely depleted, an alert requesting to charge the battery
will be displayed on the screen. The AV400 will resume nor-
mal operation once it has been charged.
In normal operation, the AV400 battery needs to be replaced
about every two years. Longer charge cycles or shorter operat-
ing periods are indications that the battery should be replaced.
To replace the battery, open the battery compartment on the
narrow end of the device's underside. Use a screwdriver or
edge of a small coin to unscrew the cover. Be careful not to
touch or scratch the lenses on the back of the device. Do NOT
use a tool to remove the battery.
15 13
9/3/2014 4:48:51 PM