Maintenance And Lubrication; Maintenance & Lubrication Chart - Ransomes HR300 Kubota D1105T Sicherheits-, Bedienungs- Und Wartungshandbuch

8 MAINTENANCE AND LUBRICATION

8.1 MAINTENANCE & LUBRICATION CHART ____________________________
Interval
First 50 hours
Daily
10 hours
Weekly
Every 50
hours
End of
season
Every 1000
hours
A = Lift Arm Pivot, B = Cutting Unit Pivot, C = Pedal Mechanism, D = Cutting Unit Bearing
A Engine Oil (with filter)
B Hydraulic Oil (with filter)
C Radiator Coolant
D Fuel
The lubricating oil change intervals listed in the table below are for classes CF, CE & CD lubricating oils of API
classification with a low sulphur fuel in use. If a CF-4 or CG-4 lubricating oil is used with a high-sulphur fuel,
change the lubricating oil at shorter intervals than recommend in the table above depending on the operating
condition.horter intervals than recommend in the table above depending on the operating condition
en-59
MAINTENANCE AND LUBRICATION CHART
Item

Change Hydraulic Charge Filter Element

Check Safety Interlock System.

Check Hydraulic Fluid Level

Check Tyre Pressure

Check Engine Bay for Debris

Check for Loose Components.

Check for Hydraulic Leaks.

Check Battery Condition.

Change Hydraulic Oil & Filter
Lubricate all Grease fittings weekly
Housing, E = Steering Ram Ball Joint, (see diagram)
FLUID REQUIREMENTS
Quantity
6.4 litres
36 litres
5 litres
45 litres No 2-D (ASTM D975) Diesel
Section
8.5
7.2
8.5
4.2
8.10
8.10
8.10
8.9
8.5
Type
10W 30
ISO VG 46
50% Anti-Freeze