Water Temperature Screen; Blocked Charge Filter Screen - Ransomes HR300 Kubota D1105T Sicherheits-, Bedienungs- Und Wartungshandbuch

6.2H.5

WATER TEMPERATURE SCREEN __________________________________

If the temperature increases to 108°C, the RED LEDs (A)
flash at a rate of two flashes every four seconds. The
warning buzzer will sound at the same rate and the
"CLEAR BUGSCREEN" warning replaces the centre icons
and flashes. Press the button under the check mark to
remove warning. The RED LED's flash and buzzer will
continue until the temperature has decreased to under
108°C. When the temperature reaches 110°C, the lift /
lower function is stopped and the power take off is
disengaged. The engine will shutdown at 115°C.
This occurrence will also be logged to memory, the data to
be recorded is:
Water Temperature limit reached, Date, Time, Engine Hours,
Time above 110°C Maximum temperature reached during fault.
6.2H.6

BLOCKED CHARGE FILTER SCREEN _______________________________

This signal will not trigger a fault until the hydraulic oil is at
operating temperature. If the charge filter becomes
blocked the icon will be shown, and the RED LED's
(A) will flash at a rate of a 1s flash every 5 seconds.
The buzzer relay will be triggered at the same rate of
high for 1s every 5 seconds.
The fault will be logged to memory, information to be
stored should be:
Blocked Charge Filter, Date, Time, Engine Hours.,
Length of time engine continued to run after fault arose.
CONTROLS 6
A
Water Temperature Sensor
-System Fault-
1234.5
A
BLOCKED CHARGE FILTER
FAULT
1234.5
A
A
en-38