Cutting Unit Specification; Cutting Performance; Recommended Lubricants - Ransomes HR300 Kubota D1105T Sicherheits-, Bedienungs- Und Wartungshandbuch

4 SPECIFICATIONS
4.7

CUTTING UNIT SPECIFICATION _____________________________________________

Construction
Blade Length
Number of Blades
Blade Tip Speed
Width of Cut
Height of Cut
Height of Cut Adjustment Front
Height of Cut Adjustment Rear
Anti Scalp Roll
Transmission
NOTE
These cutting units are made to cut grass of maximum height 82 mm down to the available height of cut range.
4.8

CUTTING PERFORMANCE _____________________________________________

152 cm Deck:
2.46 hectares/hr. at 18 kph (6.07 Acres/hr at 11mph)
160 cm Deck:
2.58 hectares/hr. at 18 kph (6.4 Acres/hr at 11mph)
183 cm Deck:
2.96 hectares/hr. at 18 kph (7.31 Acres/hr at 11mph)
10% allowance is included for normal overlaps and turning at the end of each cut.
4.9

RECOMMENDED LUBRICANTS _________________________________________

Engine oil:Must be to MIL-L-2104C or to A.P.I. Classification CD grades. [10W-30]
Above 25°C (77°F)
0°C to 25°C (32°F to 77°F)
Grease: Shell Darina R2, or equivalent.
en-21
152cm Deck
533mm
4463 m/min
1524mm
Three antiscalp rollers on front of deck and four antiscalp rollers on rear of
deck.
TEMPERATURE
Below 0°C (32°F)
160cm Deck
Heavy duty welded pressed steel construction
559mm
4630 m/min
1600mm
25mm - 115mm
Castor wheels with spacers.
Multi-hole plates and pins.
By individual hydraulic motor to each cutter blade.
SAE10W-30 or SAE10W-40
SAE10W-30 or SAE10W-40
SAE10W-30 or SAE10W-40
183cm Deck
635mm
3
5318 m/min
1828mm
VISCOSITY
SAE30 or
SAE20 or
SAE10W or