Lighting Kit (Optional); Seat Right Hand Arm Rest & Pod - Ransomes HR300 Kubota D1105T Sicherheits-, Bedienungs- Und Wartungshandbuch

6.10

LIGHTING KIT (OPTIONAL) ________________________________________

Lighting Control Stalk
A Push away from operator to turn lights on.
B Pull towards operator to flash headlights.
C Move stalk up to indicate left turn.
D Move stalk down to indicate right turn.
E Push stalk in to sound horn.
NOTE: Side lights will operate when ignition is in the
run position
When the lighting kit is fitted a brake light function is available. If brake lights are used rear view mirrors must be
fitted.
6.11 SEAT RIGHT HAND ARM REST & POD ______________________________
The right hand arm rest of the seat has an extension
mounted to it which carries the control pod.
To obtain a comfortable operating position:
a Release hand wheel (A).
b Using both hands grip the arm rest and lift or
lower the arm rest. It will move in a circular
motion (X) either moving up and forward or
down and rearwards.
c When the desired position is obtained lock by
tightening the hand wheel (A).
The pod can be pivoted in the horizontal plane (Y),
independently of the arm rest by:
d loosening the three screws (B) holding the pod to the arm rest extension.
e Swivel pod to desired position.
f Tighten the three screws (B).
The whole arm rest extension can be pivoted in the horizontal plane (Z).
g Remove the arm rest cushion by removing the four screws (D).
h Loosen the three locknuts (E) fitted to studs (C).
j Swivel the arm rest extension to the desired position.
k Tighten the three locknuts (E)
l Refit the arm rest cushion with the four screws (D)
A
X
D
E
C
A
CONTROLS 6
B
E
C
D
Y
B
Z
en-48