Cutting Unit Switches; Variable Cylinder Speed; Backlapping Lever - Ransomes Parkway 2250 plus LGNN040 Betriebshandbuch

RANSOMES PARKWAY 2250 PLUS
6 CONTROLS
SAFETY AND OPERATORS MANUAL

6.10 CUTTING UNIT SWITCHES

To commence cutting ensure speed limiter is in
mow position and the cylinders have been lowered
Push bottom of the rocker switch (A) and depress
foot switch (B) Push top of rocker switch to stop
cutter unit rotation. (Cutting units stop rotating
automatically when raised.)
NOTE: The backlapping lever must be in the
drive position before cylinders wil rotate.

6.11 VARIABLE CYLINDER SPEED

The speed of rotation of the cutting cylinders is adjustable
by means of the handwheel (A) situated on the left hand
side of the operator. Cylinder speed should be set to
maximum in normal cutting conditions. In very long
growth conditions, cylinder speed should be reduced to
obtain best finish,cylinder speed should also be reduced
when cutting very short, dry grass to prevent excesive
cylinder and bottom blade wear. Rotate the hand wheel
clockwise to increase cylinder speed, anticlockwise to
decrease cylinder speed.

6.12 BACKLAPPING LEVER

The lever (B) sets cutting cylinder rotational direction
with three positions:
(a) fully towards the seat for mowing, (b) fully away
from the seat for backlapping and (c) set in the mid
position for neutral. See the separate cutting unit
operator's manual for an explanation of the
backlapping procedure.
GB-15