Installing Washing Machine; Aligning The Washing Machine - hanseatic HWMB814C Gebrauchsanleitung

2. Remove the transport safety devices and
keep them safe so that you can use them
for another transportation.
(c)
3. Close off the transport safety holes with
the enclosed covers (c).
4. Keep the transport safety devices in a
safe place. Reinstall the transport safety
devices every time the appliance is moved
– when moving home or returning the ap-
pliance!
Installing the transport safety
devices
• Reinsert the transport safety devices (15)
before moving the washing machine every
time. For this purpose, follow the steps de-
scribed above in the reverse sequence.
Set-up and connection

Installing washing machine

The installation site must fulfil the following
requirements:
– The installation site must be frost-proof.
– There must be a water supply and drain as
well as a power socket nearby.
– Even after setting up the appliance, the
mains plug must be easily accessible.
– The ground must be secure, even, clean
and dry.
– The appliance must not be positioned di-
rectly on a rug or carpet as it will then not
be adequately ventilated and can overheat.
Where rugs, carpet, parquet or wood-
en floorboards are present, place a sta-
ble wooden plate measuring at least
60 × 60 cm underneath the appliance.
– When positioning on a wooden plate or
base, these must be equipped with indenta-
tions for the screw-on feet so that the appli-
ance does not migrate off it when spinning.
– For smooth tiled floors, lay a rubber mat un-
der the screw-on feet.

Aligning the washing machine

1. Loosen the lock nut of one of the screw-on
feet underneath the appliance.
2. Manually screw or unscrew each foot until
the washing machine is level.
3. Twist the lock nuts (39) of all screw-on feet
upwards to the underside of the appliance
and tighten the lock nuts against the un-
derside of the appliance.
Page EN-33
(39)