Brother E-Derie Bedienungsanleitung Seite 231

15. Changing the base line for pattern sideways movement from right edge to center of pattern
15. Ändern der Grundlinie für Seitwärtsbewegung von Mustern von der rechten Kante auf die Mitte des Musters
15. Modification de la ligne de base du mouvement latéral du motif du bord droit au centre du motif
15. Cambio de la línea de base para el movimiento lateral del patrón desde el borde derecho al centro del patrón
I Zigzag base line position indicator w
If the zigzag base line position has been set to something other than
will illuminate so that you can check whether the zigzag base line position has been set to a position other than the
center.
I Zigzag width
When DIP switch 2-7 is set to OFF, the trimming margin base line position changes to the zigzag base line position.
Accordingly, the zigzag width setting range has no effect on the trimming margin.
G Relationship between zigzag base line position and zigzag width (when the maximum zigzag width is 5 mm)
By way of example, consider a sewing pattern (Figure A) with a zigzag base line position set to
width set to AA AA. If the zigzag base line position is set to
edge (Figure B). The sewing pattern cannot move any further to the left even if a larger setting is made. (Even if the
zigzag base line position is set to
(Figure C.)
AA AA
However, in this case, if the zigzag width is set to
produced.
<Example>
(5mm)
A
3mm
-------- 0
Base line
--------3.0
Zigzag width
G Relationship between zigzag base line position and zigzag width for backtack stitches
If the zigzag width for backtack stitches is different from the normal zigzag width and the zigzag base line is set in
such a way that the sewing pattern exceeds the maximum zigzag width, the zigzag width limit setting (see above)
can be made separately for normal zigzag stitches and zigzag backtack stitches.
(The three examples given below show situations where the zigzag base line position is changed while the normal
zigzag width and zigzag width for backtacking remain the same.)
<Example>
Start backtacking
Normal zigzag sewing
End backtacking
Base line .............................................
Zigzag width .......................................
Zigzag width for start backtacking ...
Zigzag width for end backtacking .....
All manuals and user guides at all-guides.com
AA AA, the sewing pattern position will be the same as if the setting had been
AA, a sewing pattern such as that shown in Figure D will be
AA
(5mm)
B
3mm
L1.0
3.0
(5mm)
A
3mm
ZE-8570,8580
AA, the zigzag base line position indicator w
AA
AA AA, the pattern will be moved over toward the left
(5mm)
C
3mm
L1.5
3.0
(5mm)
B
3mm
AA AA and a zigzag
(5mm)
D
2mm
1558M
L1.5
2.0
(5mm)
C
3mm
1559M
212