Inhaltsverzeichnis
Werbung
7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES
I Setting the zigzag width for start backtack stitches (additional DIP switch function)
(Be sure to turn off the power before changing any of the DIP switch settings. Refer to page 185.)
Zigzag width for section A start
<Example>
backtack stitches (3.0mm)
Zigzag width for section B start
backtack stitches (1.5mm)
1523M
Zigzag width
e
r
e
r y
t
Zigzag width
Zigzag width
for section A
for section B
Turning the start backtack function on and off
Carry out the following settings after the thread has been trimmed (or after the treadle has been depressed backward
for the ZE-8570-A01).
The condition changes as shown below each time the start backtack key q is pressed.
•
Start backtacking is carried out when the start backtack indicator w is illuminated.
•
* The zigzag width at the sewing start will change when the start backtack indicator w is turned on and off, and so
the needle bar will move at this time by the amount of the difference.
w
Zigzag width display, etc.
1448M
103
All manuals and user guides at all-guides.com
1452M
w
q
1453M
w
q
1454M
Illuminated
q
Number of start
backtack stitches
1449M
ZE-8570,8580
When DIP switch 2-5 inside the control box is set to OFF,
the zigzag width for start backtack stitches can be set sepa-
rately from the normal zigzag width.
(You must set the end backtack zigzag width at this time
too. Be sure to make this setting if carrying out end
backtack sewing too.)
1. Press the start backtack key q.
• The indicator w will illuminate and the start
backtacking function will turn on.
• The AB indicator e will illuminate and the number
of start backtack stitches will appear in the LED dis-
play r.
2. To change the number of start backtack stitches, use
selection keys t to change the setting value.
the
3. Press the start backtack key q once more.
• The indicator w and the AB indicator e will re-
main illuminated, and the tack width indicator y
will also illuminate.
• The zigzag width for the start backtack stitches will
appear in the LED display r. (For example,
indicates widths of 3.0 mm for section A and 1.5
mm for section B and that start backtacking will be
carried out.)
selection keys t to change the zigzag
4. Use the
widths.
5. Start backtacking will be carried out when the treadle
is depressed.
Illuminated
Zigzag width for start
backtack stitches
1455M
AA AA
Off
Zigzag width display
1450M
Werbung
Inhaltsverzeichnis
Fehlerbehebung
