Brother E-Derie Bedienungsanleitung Seite 133

I Setting the zigzag width for end backtack stitches (additional DIP switch function)
(Be sure to turn off the power before changing any of the DIP switch settings. Refer to page 185.)
<Example>
Zigzag width
Zigzag width
for section C
end backtack
stitches
Zigzag width for section D end
1524M backtack stitches
e r
t
e r y
t
Zigzag width Zigzag width
for section C for section D
Turning the end backtack function on and off
The condition changes as shown below each time the end backtack key q is pressed.
•
End backtacking is carried out when the end backtack indicator w is illuminated.
•
w
Zigzag width display, etc.
1492M
All manuals and user guides at all-guides.com
1462M
w q
1463M
w q
1464M
Illuminated
q
Number of end
backtack stitches
1460M
ZE-8570,8580
7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES
When DIP switch 2-5 inside the control box is set to OFF,
the zigzag width for end backtack stitches can be set sepa-
rately from the normal zigzag width. (You must set the
start backtack zigzag width at this time too. Be sure to
make this setting if carrying out start backtack sewing
too.)
1. Press the end backtack key q.
• The indicator w will illuminate and the end
backtacking function will turn on.
• The CD indicator e will illuminate and the number
of end backtack stitches will appear in the LED dis-
play r.
2. To change the number of end backtack stitches, use
selection keys t to change the setting value.
the
3. Press the end backtack key q once more.
• The indicator w and the CD indicator e will re-
main illuminated, and the tack width indicator y
will also illuminate.
• The zigzag width for the end backtack stitches will
appear in the LED display r. (For example,
indicates widths of 1.5 mm for section C and 3.0
mm for section D and that end backtacking will be
carried out.)
selection keys t to change the zigzag
4. Use the
widths.
5. When sewing is carried out and then the treadle is
depressed backward, end backtacking will be carried
out. (For the ZE-8580, the thread will then be trimmed.)
Illuminated
Zigzag width for end
backtack stitches
1465M
AA AA
Off
Zigzag width display
1493M
114