Via The Network; Structure Of The Web Interface; Operating The Web Interface - Mennekes AMTRON Professional+ E 7,4 Betriebs Und Installationsanleitung

6.5.3 Via the network

Once the product is integrated into the network via
Ethernet, the web interface can also be reached via
a terminal device that is located in the same net-
work.
Requirement(s):
ü The product must be integrated into a network.
1 "6.8 Integrating the product into a local net-
work" [} 27]
ü A terminal device (e.g. PC, laptop) must also be
integrated in the network via the router /
switch.
ü The IP address of the product must be known.
If the IP address of the product is not known
(e.g. due to dynamic IP address configura-
tion by a DHCP server), the IP address can
either be set via a network scan (installed
as a free tool on the terminal device) or via
the web interface of the router / switch.
u Open web browser on terminal device.
The web interface can be reached via http://IP
address.
Example:
n IP address: 192.168.0.70
n The web interface can be reached via:
http://192.168.0.70
u Enter the user name (operator) and password.
1 Password: See Setup data sheet
By entering the relevant IP address in the
web browser, each product in the network
can be configured via the terminal device.
The serial number of the respective product
is displayed at the top right of the login
page for better correlation with the setup
data sheet.
6.6

Structure of the web interface

The tasks described in this section may only
be carried out by a qualified electrician.
26
1
6
Fig. 13: Structure of the web interface for firmware
version 5.12.3 (example)
1 Menu
2 Parameter
3 Note / information *
4 Setting / status
5 Language selection button
6 Button to reset and save the changed settings
and restart the product
* The notes / information (3) contain a great
deal of important information that provides
tips on the respective parameter and for
configuration purposes.
As of firmware version 5.12.3, the display of the
web interface has been adapted. When updating
the firmware from the old web interface (firmware
version lower than 5.12.3) to the new web interface
(firmware version 5.12.3 or higher), the new web in-
terface must be activated manually.
1 "8.3.2 Activate new web interface" [} 44]

6.6.1 Operating the web interface

u Configure the product taking into account the
local conditions and customer requirements.
After the product has been fully configured,
a restart is required.
u Click the "Restart" button to restart the
product.
5
2 3 4