Mennekes AMTRON Professional+ E 7,4 Betriebs Und Installationsanleitung Seite 87

With Autocharge, authorisation takes place auto-
matically by means of a unique vehicle ID (e.g. the
vehicle's MAC address).
n Autocharge is not the same as Plug and
Charge according to ISO 15118, in which
the authorisation takes place by means
of a contract certificate from the eMobil-
ity Service Provider (EMP), which must be
stored in the vehicle.
n Autocharge is not an official or standard-
ised function of the automobile or char-
ging infrastructure manufacturers.
n MENNEKES cannot guarantee that
Autocharge will always function
properly with the vehicles in the list
below. Compatibility with
Autocharge can vary, including de-
pending on the model and software
version of the vehicle. The list results
from various field tests with the lis-
ted vehicles.
n Autocharge is currently of an experi-
mental nature and will be optimised
and improved in the next firmware
versions.
Requirement(s):
ü For connection to a backend system: The
backend system supports Autocharge.
ü The vehicle can transmit a unique vehicle ID.
You can find a list of the vehicles in which
Autocharge was successfully tested by
MENNEKES on our website at:
https://www.chargeupyourday.de/service-
faq/autocharge/
The vehicle ID is treated in the same way as an
RFID UID.
u Navigate to the menu "Authorization" > "HLC
15118" and set the following parameters:
Parameter Setting
Autocharge u Select "On".
u Click the "Save" button to save the setting(s).
For connection to a backend system
The configuration in the backend system depends
on the respective backend system and therefore
cannot be described in detail in this document.
1. Read the vehicle ID in the backend system. First
connect the product and the vehicle to the char-
ging cable.
2. Enter the vehicle ID in the backend system or
enter the vehicle ID in the web interface in the
parameter "List of entries in OCPP whitelist" or
"List of entries in local whitelist".
Without a connection to a backend system
1. Read the vehicle ID in the web interface.
u Navigate to the menu "Authorization" > "HLC
15118" and set the following parameters:
Parameter Setting
15118 Configura- u Select "On (No PlugN-
tion Charge)".
u Connect the product and the vehicle to the
charging cable.
u Enter the ending "/legacy/operator" in the ad-
dress line of the web browser (e.g.
192.168.123.123/legacy/operator).
u Enter the user name (operator) and password.
1 Password: See Setup data sheet
u Navigate to the menu "> 15118" . The menu
"> 15118" only appears if the parameter "15118
Configuration" is switched on.
u The vehicle ID is displayed under "Event Log-
ger".
u Copy the vehicle ID to the clipboard or note it
down.
2. Enter the vehicle ID in the web interface.
u Delete the ending "/legacy/operator" in the ad-
dress line of the web browser (e.g.
192.168.123.123).
u Enter the user name (operator) and password.
1 Password: See Setup data sheet
EN
35