Reset The Configuration To The Factory Setting; Testing The Product; Closing The Product - Mennekes AMTRON Professional+ E 7,4 Betriebs Und Installationsanleitung

u Navigate to the menu "Authorization" and set
the following parameters:
Parameter Setting
List of entries in u Enter the vehicle ID.
local whitelist
15118 Configura- u Select "Off".
tion
u Click the "Save" button to save the setting(s).
6.11 Reset the configuration to the factory
setting
The tasks described in this section may only
be carried out by a qualified electrician.
u Enter the ending "/legacy/operator" in the ad-
dress line of the web browser (e.g.
192.168.123.123/legacy/operator).
u Enter the user name (operator) and password.
1 Password: See Setup data sheet
u Click the button "Operator Default & Restart" to
restore the factory settings and restart the
product.

6.12 Testing the product

The tasks described in this section may only
be carried out by a qualified electrician.
u At initial start-up, test the product in accordance
with IEC 60364-6 and the applicable national
regulations (e.g. in Germany: DIN VDE
0100-600).
The test can be carried out in conjunction with the
MENNEKES test box and standard-compliant test
equipment. The MENNEKES test box simulates
vehicle communication. Test boxes are available as
an accessory from MENNEKES.
36

6.13 Closing the product

The tasks described in this section may only
be carried out by a qualified electrician.
ATTENTION
Material damage due to crushed components or
cables
Damage and malfunctions can occur due to
crushed components or cables.
u When closing the product ensure that compon-
ents or cables are not crushed.
u Fix components or cables in place if necessary.
5
Fig. 17: Closing the product
u Lift the front panel (3) upwards and secure it
with the screws (4).
u Attach the top section of the housing (1) and se-
cure it with the screws (2) and (5). To do this,
use the shortened Allen key supplied.
Item Screw
2 M5 x 16
4 M5 x 10
5 M5 x 35
2.
4
1.
3
Max. tightening torque
1.2 Nm
0.5 Nm
1.2 Nm
1
2