Installing The Product On The Wall - Mennekes AMTRON Professional+ E 7,4 Betriebs Und Installationsanleitung

5.5

Installing the product on the wall

ATTENTION
Material damage due to uneven surface
Installing on an uneven surface can cause the hous-
ing to go out of shape, so that the protection class
is no longer guaranteed. Consequential damage of
electronic components can occur.
u Only install the product on an even surface.
u If necessary, level out uneven surfaces with
suitable measures.
MENNEKES recommends installing at an er-
gonomically sensible height depending on
the height of the body.
The fastening materials provided (screws
and dowels) are only suitable for installation
on concrete, brick or wooden walls.
ATTENTION
Material damage due to drilling dust
Consequential damage of electronic components
can occur if drilling dust gets into the product.
u Make sure that drilling dust does not get into
the product.
u Do not use the product as a drilling template
and do not drill through the product.
u Create the drill holes using the drilling template
(included in the delivery contents) or first mark
the drill holes using the illustration "Drilling di-
mensions [mm]" and then drill them. The dia-
meter of the holes depends on the chosen
mounting hardware.
Fig. 7: Drilling dimensions [mm]
u Insert the supply line into the product through a
cable entry together with the data line (if applic-
able). To do this, a hole has to be made in the
respective membrane.
To prevent the ingress of rainwater, the
hole in the membrane should not be larger
than the pipes.
Approx. 30 cm of cable are required for the
supply line inside the product.
EN
19