Transporting The Product; Opening The Product - Mennekes AMTRON Professional+ E 7,4 Betriebs Und Installationsanleitung

Supply line fuse (e.g. miniature circuit breaker,
NH fuse)
n National regulations must be observed
(e.g. IEC 60364‑7‑722 (in Germany DIN
VDE 0100‑722)).
n The fuse for the supply line must be de-
signed for the product, taking account,
among other considerations, of the rating
plate, the required charging power and
the supply line (line length, cable cross-
section, number of outer conductors, se-
lectivity).
For product variants with integrated cir-
cuit breaker:
n The rated current of the fuse for the sup-
ply line must not exceed 100 A.
For product variants without integrated
circuit breaker:
n The rated current of the fuse for the sup-
ply line must not exceed 32 A (with C
characteristics).
Shunt release
Only valid for the product variants with a switching
output for controlling an external shunt release.
u Check whether a shunt release is legally pre-
scribed in the country of use.
1 "2.2 Intended use" [} 4]
n The shunt release must be positioned
next to the line circuit breaker.
n The shunt release and the line circuit
breaker must be compatible with each
other.
18
5.3

Transporting the product

ATTENTION
Material damage due to improper transportation
Collisions and impacts may damage the product.
u Avoid collisions and impacts.
u Transport the product to the place of installa-
tion in the packed condition.
u Do not use bolts for fastening the front panel as
a transport aid or handle.
u Set the product down on a soft base.
5.4

Opening the product

The tasks described in this section may only
be carried out by a qualified electrician.
2
Fig. 6: Open the product
When delivered, the top section of the housing (1) is
not attached with screws. The screws (2) are in-
cluded in the delivery contents.
u Unscrew screws (2) if necessary.
u Remove the top section of the housing (1).
u Unscrew screws (4) and fold down the front
panel (3).
1.
4
2.
3
1
2