Use; Select Operating Mode; Select Direction Of Rotation; Switching On And Off - Parkside PBH 1050 C3 Originalbetriebsanleitung

Use

Select operating mode

Function selector
♦ Press and hold the release button
function selector switch
selector switch so that the required symbol
engages at the arrow mark:
Function
Drilling
Hammer drilling
Chiselling
Chisel position adjustment
Adjusting chisel position
You can rotate the tool to the required position
for chiselling using this function.
♦ Turn the function selector switch
position .
♦ Turn the tool in the tool holder
required position.
♦ Turn the function selector switch
position for the chiselling function.
■ 8 │ GB │ IE
on the
. Turn the function
Symbol
to
to the
to

Select direction of rotation

♦ Select the direction of rotation by adjusting
the right/left rotation switch
WARNING!
► The right/left running switch
be used/adjusted if the appliance is at a
standstill.
Switching on and off
Switching the appliance on
♦ Press the ON/OFF switch
Switching the appliance off
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
pressed position with the ON/OFF switch lock
button .
Switching off continuous operation
♦ Press the ON/OFF switch
again.

Preselecting rotational speed

You can use the speed preselector wheel
preselect the rotational speed. Level 1 (low rota-
tional speed) up to level 6 (high rotational speed).
The speed you select depends on the material to
be processed. Work out the right setting with this
practical test:
–
Levels 4–6: high rotational speed:
for hammer drilling/chiselling in concrete
or stone.
–
Levels 1–3: medium rotational speed:
for drilling in steel or wood.
NOTE
► The set speed is only reached in continuous
operation.
.
may only
.
.
. Lock it in the
and release it
to
PBH 1050 C3