Technical Data - Parkside PBH 1050 C3 Originalbetriebsanleitung

Technical data

Rated power consumption
Rated voltage
Rated idling speed
Stroke rate
Impact energy
Max. drill diameter
Diameter drill chuck
Protection class
Meaning
Concrete
Masonry
Steel
Wood
Core cutter
Noise emission value
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Hammer drilling
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Chiselling
Sound pressure level
Uncertainty K
Sound power level
Uncertainty
Wear hearing protection!
PBH 1050 C3
1050 W
230 V ∼, 50 Hz (AC)
n 0–980 rpm
0
0–5300 bpm
3 J
13 mm for steel
32 mm for wood
26 mm for concrete
2–13 mm
II / (double insula-
tion)
Symbol
L = 90 dB (A)
pA
K = 3 dB
L = 101 dB (A)
WA
K = 3 dB
L = 93 dB (A)
pA
K = 3 dB
L = 104 dB (A)
WA
K = 3 dB
Total vibration value
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Hammer drilling
in concrete a
h(HD)
Chiselling a
h(CHeq)
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
WARNING!
► The vibration level will vary according to the
use of the power tool and may sometimes be
higher than the value specified in these
instructions. Regular use of the power tool in
this way may cause the user to underestimate
the vibration. Try to keep the vibration loads
as low as possible. Measures to reduce the
vibration load are, e.g. wearing gloves and
limiting the working time. Wherein all states
of operation must be included (e.g. times when
the power tool is switched off and times where
the power tool is switched on but running
without load).
= 13.7 m/s 2 , K = 1.5 m/s
= 15.0 m/s 2 , K = 1.5 m/s
GB │ IE │ 3
2
2
■