Athena GET 2ND INJ. KIT Installationsanleitungen Seite 5

INJECTOR FIXING BRACKET INSTALLATION
1.
Pull out the second
injector harness from
the manifold, passing
it through the Ø 6 mm
/ 0.24" injector harness
hole, made previously
(Section C, "Manifold",
step 5). The harness
must stick out from the
manifold about 210 mm
/ 8.27". Pay attention to
the injector cable rubber
grommet: it must be
properly fitted on the
manifold surface.
2.
Pass the upper part
of the fuel hose plug
(manifold) of hose D
through the Ø8 mm /
0.31" fuel hose hole,
made previously (Section
C, "Manifold", step 5).
EN
2nd
injector
harness
Outside
Inside
Outside
Inside
D
GET
fuel hose
8
3.
Align the supplied
metal bracket on
the outer part of the
manifold over the three
holes made previously
(Section C, "Manifold",
step 3). Fix the metal
bracket and the second
injector together with
the screws and washers
supplied in GET kit. Apply
a strong thread locker
(e.g. Loctite 278). The
second injector is now
fixed to the manifold.
ATTENTION:
Make sure that
the injector is
well positioned:
looking at it from
the throttle body,
the injector must
be perfectly
centered.
2ND INJECTOR KIT INSTALLATION
1.
Connect the end
of hose A to the OEM
injector.
Outside
Inside
A
To OEM injector
9 EN