Athena GET 2ND INJ. KIT Installationsanleitungen Seite 4

2. Cut GET fuel hose, included in the kit, as follows:
C: 300 mm / 11.81"
D: 150 mm / 5.91"
The remaining part of GET fuel hose will not be used. C and D will
be linked together and connected to GET 2nd injector.
300 mm / 11.81"
C
3. Install the fuel hose plug in an end of hose C. Use a Ø 15
mm / 0.59" hose clamp to fix it. Install the rubber grommet
provided in the kit on the other end. Attach this side of the hose
to the 3-way fitting and fix it with Ø13 mm / 0.51" hose clamp.
In order to avoid scratches, the grommet will keep the hose
clamp away from the cylinder head cover.
GET fuel hose
300 mm / 11.81"
To GET 2nd Injector
4. Install the supplied white fuel hose plug (manifold) in an end
gk-inj2-0018
of D hose fixing it using a Ø 15 mm / 0.59" hose clamp.
5. Connect the A, B and C hoses with the 3-way fitting included
in the kit. Fix them with Ø13 mm / 0.51" hose clamps.
EN
10 mm / 0.39" 150 mm / 5.91"
D
C
6
D. 2ND INJECTOR KIT INSTALLATION
2ND INJECTOR ASSEMBLY
1.
Use the two red
supplied spacers and
screws to fix the red fuel
rail and the injector to
the 2nd injector support
bracket. Do not forget the
seal. We suggest applying
a strong threadlocker (e.g.
Loctite 278).
2.
Attach the D hose
to the fuel rail and fix
it with a Ø 15 mm /
0.59" hose clamp. Plug
the male connector
of the second injector
harness into the second
injector. Bundle hose and
harness together with a
couple of zip ties.
D
7 EN