Mounting Bracket - Athena GET 2ND INJ. KIT Installationsanleitungen

4.
Connect the other
D
side of the "D" fuel hose
to the second injector
fuel rail and fix it with
a 15 mm / 0,59" hose
clamp.
ATTENTION:
THE COUPLER AND THE FUEL HOSE MUST BE
PROPERLY FITTED IN ORDER TO AVOID AIR ESCAPE.
5.
Use the supplied
screws to fix the metal
bracket, included in GET
kit, outside the manifold
and block the second
injector support bracket
inside the manifold.
6.
Finish fixing the
second injector support
inserting the screws
inside the two holes
milled (section C /
MANIFOLD / step 3).
gk-inj2-0006
EN
Inside Outside
8
INJECTOR KIT INSTALLATION
1.
Connect the end of
the "A" hose to the OEM
injector.
2.
Connect the end of
the "B" hose to the fuel
hose plug installed on
the manifold (section D

/ MOUNTING BRACKET

INSTALLATION / step 2).
3.
Re-install the manifold.
4.
Remove the protective
cap from the "INJ2"
GET ECU connector and
plug it to the female
second injector harness
connector.
A
To OEM injector
C
GET
fuel hose
Outside
D
Inside
Second
GET
injector
harness ECU
9 EN