Mounting Bracket Installation - Athena GET 2ND INJ. KIT Installationsanleitungen

FUEL HOSES
1. Remove the OEM fuel hose. Check on your motorbike's
workshop manual where to find it. Cut the OEM fuel hose to the
following measure (do not consider couplers in the measure):
A (OEM injector side): 60 mm / 2.36"
B (Fuel pump side) = remaining OEM fuel hose length
Shorten the B hose of 10 mm / 0,39". This chunk will not be used.
60 mm / 2.36" 10 mm / 0.39"
A
To OEM injector
2. Cut the GET fuel hose included in the kit as follows:
C: 310 mm / 12.20"
D: 150 mm / 5.90"
The remaining part will not be used.
3. Install the fuel hose plug on the C hose.
150 mm / 5.90 " 310 mm / 12.20 "
D
4. Connect A and B fuel hoses to the 3-way fitting using the 13
mm / 0,41" hose clamps included in the kit. Connect the C hose
to the 3-way fitting using the 15 mm / 0,59" hose clamps,
included in the kit.
EN
B
To the fuel pump
C
6
D. 2nd INJECTOR KIT INSTALLATION

MOUNTING BRACKET INSTALLATION

1.
Pull out from the
manifold the second
injector harness.
The
harness must stick out
from the manifold about
180 mm / 7,09". Pay
attention to the injector
cable rubber grommet: it
must be properly fitted on
the manifold surface.
gk-inj2-0006
2.
Install the fuel hose
plug (manifold) supplied
in GET kit on the fuel hose
hole previously milled
(section C / MANIFOLD /
step 6). Connect inside
the manifold the "D"
fuel hose to the fuel hose
plug. Fix it with a 15 mm /
0,59" hose clamp.
3.
Assembly the fuel
rail, the spacers and
GET second injector on
the 2nd injector support
bracket with the supplied
screws and washers, as
shown in the picture.
2nd
injector
harness
Outside
Inside
Outside
Inside
D
GET
fuel hose
7 EN